- Make sure this fits by entering your model number.
- 10 Amp 120VAC Remote Charger Power Supply, Red (Recommended Replacement for FCPS-24S8, HPF24S8, HPFF8, HPF902ULADA)
The PS Series is a remote power supply line from FireLite Alarms and is a direct replacement for the FCPS-24FS6/8 Series. The FLPS6(C) is a 6 amp and the FL-PS10(C) is a 10 amp, remote power supply with battery charger that may be connected to any 12 or 24 volt fire alarm control panel (FACP) or used as a standalone power supply. The PS Series provides 24 VDC power for NACs (notification appliance circuits) configured as either Class B or Class A (requires the ZNAC-PS option card) with multiple sync protocol options. The PS Series also provides auxiliary power, constant or resettable, suited for detectors, annunciators, door holders, and other fire alarm system peripherals. The PS Series cabinet can hold two 7 AH or 18 AH batteries and can charge up to 33 AH batteries in a separate cabinet. Features Up to five (6 amp model) or seven (10 amp model) independently-configurable, power-limited output circuits for: Class B and/or Class A NACs Class B and/or Class A resettable or non-resettable 24V auxiliary power door holder power Converts from Class B to Class A wiring without losing any outputs using the ZNAC-PS converter card (sold separately) Optimal for powering four-wire smoke detectors, annunciators, and other system peripherals requiring regulated power Configurable for ANSI Temporal 3 or Temporal 4 coded output UL-Listed NAC synchronization using System Sensor, Wheelock, Gentex, or AMSECO appliances Synchronization can be triggered from FACP NAC/remote sync outputs, cascaded power supply, or a control module, single or multi, which may be housed within the power supply cabinet Ability to cascade up to four power supplies Two (6 amp model) or three (10 amp model) fully-isolated input/ control circuits which can be programmed to any output Two Form C normally-closed trouble relays for AC Trouble and General Trouble, Ground Fault relay available on Canadian models only 6 or 10 amp full load output, respectively, with 3 A maximum/circui